Drive Shaft - AGFA Avantra 36/44 Service Manual

Replace:
1. Loosen the entry drive idler.
2. Place the new belt over the belt wheel.
3. Reverse Steps 4 and 5 above.
4. Replace the tension belt with idler and tighten.
CAUTION: Do not over tighten the belt.

3.13.2 Drive Shaft

1. Remove the entry rack drive belt. See Section 3.13.1, Drive Belt above.
2. Remove the allen set screw from the belt wheel.
3. Remove all three racks.
4. Loosen the three drive motor mounting bolts to loosen the belt. Slide the
belt from the idler, and remove the belt from the drive shaft. Refer to
Figure 3-22.
1
Figure 3-22 Bearing bracket and drive gear.
–Bearing bracket (front). –Bearing bracket bolts. –Drive gear with set screw.
Section IV: On-line Processor
2
3
Removal and Replacement 3-27