AGFA Avantra 36/44 Service Manual page 151

Avantra 36/44 Service Manual
NOTE:
Remote configuration of this modem is not supported. Configuration
must be done at the time of installation. Other modems may support
this feature. Refer to manufacturer's documentation.
After the modem has been configured, store the settings in the active configuration profile
(usually 0) with the following command:
AT&W0
The remote diagnostic center's telephone number (for the auto dial-out feature) should now be
entered into the modem's non-volatile RAM. Four telephone numbers can be stored in the
modem's memory: 0 - 3. The Avantra's firmware uses only one specific location when dialing
out: location 1 (ATDS=1).
Hardware Connection:
After configuring, install and connect the modem to the system. Follow these procedures:
1. Open the right bottom and top side doors. Locate the modem mounting bracket on
the side of the electronics enclosure.
2. Remove the two (2) nuts securing the mounting clip on the modem bracket and
remove the clip.
3. Slide the modem into the bracket with the connectors facing out. Re-install the
mounting clip.
4. Locate the power and diagnostic port connectors on the DEC PCB (bottom of electron-
ics enclosure).
5. Plug the DC power cable into the DEC and route the cables along the bottom of the
door up to the modem.
6. Plug the power connector into the modem.
7. Connect the 25-pin end of the adapter cable to the diagnostic port on the DEC. Con-
nect the 9-pin end of the adapter cable to the modem serial cable.
8. Route the serial cable along the bottom of the door up to the modem.
9. Plug the DIN connector into the modem.
10. Route the telephone cable (with RJ11 connector) through the cable access hole under
the system. Continue to route the cable up the back of the system, over the cross
brace and along the bottom of the door and up to the modem.
11. Plug the cable into the telephone jack marked LINE.
12. Turn the system on and depress the power switch on the modem to turn it on.
Make sure that the Power On/Ready LED on the modem illuminates. The modem
should now be ready for remote communication.
3-64 Diagnostics