AGFA Avantra 36/44 Service Manual page 510

Avantra 36/44 Service Manual
6. Using a 9/64" hex wrench, remove the four (4) hex screws at the top of the
head.
CAUTION:
cable end.
7. Pull the cable and hook up through the hole in the head.
8. Spread the sides of the head and slide the head assembly free.
9. Cut the wrap to free the motor power cable on the top of the head. Using
a pin removal tool, remove the pins in the plug.
WARNING:
purposes.
10. Push the wire through the hole.
11. Flip the motor assembly over and remove the P-clamp holding the wire in
place.
12. Using a 5/32" allen wrench, remove the two (2) screws attaching the motor
to the plate.
Replace:
1. Replace the 5/32" allens.
2. Align the motor coupler with the coupler on the mount until they engage.
3. Slide the motor forward.
4. Tighten the hex screws at the top.
5. Put the wire end through the hole in the plate.
6. Attach the P-clamp.
7. Re-attach the plug to the wire.
8. Plug the wire in.
2-8 Removal and Replacement
While removing the screws, support the motor at the
Make note of the location of the wires for replacement