AGFA Avantra 36/44 Service Manual page 262

NOTE: When cleaning the nip drive rollers, do NOT substitute any
other tape (i.e. , masking, duct tape, etc.) for clear tape.
Substitutes may leave a sticky residue on the roller, and
any residue could cause PERMANENT DAMAGE to the roll-
ers.
5. Install the outer take-up nip assembly.
6. Install the take-up light shield cover.
7. Install the bottom front covers.
6.2.3.4 Lower Interior Area
To Clean:
1. Open the two (2) side panels.
2. Soft vacuum.
3. Clean the:
• Side panel interior surfaces and edges
• Exterior light shields
• Frame
6.2.3.5 Inner System
To Clean:
1. Remove the right and left light shields.
2. Move the carriage to the center of the drum.
3. Soft vacuum the:
• Inside of the light shields
• Accessible base and engine casting areas
4. Soft vacuum and clean the:
• Drum surface
5. Install the left and right drum light shields.
6. Close the left and right covers.
7. Install the supply cassette light shields.
8. Install the supply and take-up cassettes.
9. Close the supply cassette light shield.
10. Close the top cover.
Section I: Imagesetter
Maintenance 6-7