8. Remove the wires in the terminal block located on the left side of the housing:
a. #1
b. #3
c. #2
d. #4 (green/yellow ground wire)
Refer to Figure 3-20.
CAUTION: Note the numbering of the wires for proper replacement.
Remove the two (2) screws in the terminal block. Refer to Figure 3-20.
9. Remove the two (2) blower mount screws and pull the housing out.
1
3
Figure 3-20 Dryer blower assembly.
–Blower/dryer assembly. –Terminal block. –Blower mount screws.
1
2
4
Section IV: On-line Processor
3
2
Removal and Replacement 3-25