Avantra 36/44 Service Manual
Replace:
1. Detach the duct from the old blower and attach it to the new blower.
2. Reverse the order of the removal procedures above being careful to seat
the wires in their proper places.
3.13 Entry Rack Assembly
Drive Belt
3.13.1
The following describes how to remove and replace the entry rack drive belt.
Tools Required: Tie cutters, phillips screwdriver, 10mm wrench
Remove:
1. Turn off and unplug the OLP.
2. Remove the top covers.
3. Remove the side covers.
4. Remove the bolts securing the bearing blocks. Refer to Figure 3-21.
5. Remove the bearing blocks and drive shaft.
6. Remove the drive belt.
Figure 3-21 Entry rack drive belt assembly.
–Bearing blocks. –Entry drive belt. –Entry drive idler. –Entry drive pulley.
3-26 Removal and Replacement
1
3
4
2