Crane Cable - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual

2.2.4 Crane Cable

Tools Required: phillips head screwdriver, flat head screwdriver, 9/64" hex
wrench, pliars
Remove:
1. Using the up/down switch, lower the crane cable as far as possible.
2. Using a phillips head screwdriver, remove the four (4) screws on the front
and back cover of the head.
3. Disconnect the power cable at each end of the head.
4. Using a flat head screwdriver, remove the three (3) screws in the end stop
at the front of the boom. Figure 1-6.
5. Carefully roll the head off the boom rails. Figure 1-6. Lay the head down
on a flat surface with the top (open) end up.
6. Using a 9/64" hex wrench, remove the four (4) hex screws at the top of the
head. This Detaches The Motor Assembly.
CAUTION:
cable end.
7. Pull the cable and hook up through the hole in the head.
8. Spread the sides of the head and slide the head assembly free.
2-10 Removal and Replacement
While removing the screws, support the motor at the