1
Figure 4-18 Digital Engine Controller PCB (DEC) screw locations.
–Three screws (located in three corners of the DEC board).
–Six screws located underneath electrical enclosure.
Replace:
1. Install the new DEC board by reversing the above steps.
2. Download and restore all DEC machine parameters.
3. Download the DEC DSP and correction tables.
4. If necessary, program the DEC K1 FLASHROM.
5. Run the following imager files:
•
Continuous mode:
•
Stop/Start mode:
1x1 Horizontal Line
50% / 85% / 96% tint
Removal and Replacement 4-27
Section I: Imagesetter
2