AGFA Avantra 36/44 Service Manual page 200

5. Make sure that both the bearing and magnet retaining brackets are in the
up position and that the screws are tightened on the transfer tool. Refer to
Figure 4-27.
6. Make sure that the carriage locking pins are in the retract position (out) on
the transfer tool. Refer to Figure 4-27.
7. Insert the carriage transfer alignment pin into the hole on the engine upper
structure frame. Refer to Figure 4-28.
Line up the pin on the transfer tool left rail with the hole in the carriage left
rail.
8. Tighten the transfer tool screw, making sure that the alignment lip on the
bottom of the transfer tool right rail is up against the bottom of the carriage
right rail.
9. After the transfer tool is secured make sure that the top surface of the trans-
fer tool rails line up with the top surface of the carriage rails.
1
Figure 4-28 Inserting the carriage transfer tool.
–Carriage transfer tool.
Removal and Replacement 4-41
Section I: Imagesetter