AGFA Avantra 36/44 Service Manual page 497

Avantra 36/44 Service Manual
9. Install the stop pin through the base of the boom, which extends below
the mount. Refer to Figure 1-5. Make sure that the head of the stop pin is
on the same side as the control switches.
The locking pin locks the boom in place once the set screws have been
tightened against the adapter. Make sure the locking pin is facing straight
out as shown before tightening the set screws. Note that the adapter has
recesses for the set screws.
6
7
Figure 1-5 Mounting the boom into the adapter/mount.
–Adapter. –Four mounting plate bolts with washers .
–Mounting bracket.
1-6 Mounting
1
–Spring loaded locking pin. –Boom.
–Two allen set screws in mount. –Stop pin.
–Lock block with bolt.
2
4
3
5