Supply Jam And Media Present Sensors; Electrical Removal/Replacement Procedures - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
Replace:
1. Reverse the above removal procedure.
2. Before installing the light shields and panels, turn the system on and
launch the AVDIAG program from your PC.
3. Select Align, then Display Sensors.
4. Check the take-up media present sensor by inserting a piece of film down
the left side of the take-up cassette platform until the sensor is covered.
This should cause a change in status for the take-up media present sensor
on the PC.

4.3.10 Supply Jam and Media Present Sensors

Tools Required: 1/4" nut driver, tie wrap, 1/4" wrench
Remove:
NOTE: Before starting, make sure that the A spindle is nipped.
1. Unload any media and remove both supply cassettes.
2. If the bridge is present, put it in light mode. Lift the bridge to the up posi-
tion.
3. Push down the cassette A tray to lock. Slide the cassette B tray to the out
position.
4. Remove the two (2) screws, which are located under the bottom spindle
roller, securing the cover to the supply jam and media present sensor
assembly.
5. Open the left side door and remove the three (3) screws securing the left
supply media guide light shield.
6. Remove the two screws securing the bottom roller bearing retainer.
Remove the bottom roller.
7. Remove the two screws securing the supply and media present sensor
assembly. Remove the connectors from the assembly.
Replace:
1. Reverse the above procedure.
NOTE: To install the bottom roller, compress the spring using a tie
wrap. Put the roller in and then cut the tie wrap to remove it.
4.4 Electrical Removal/Replacement
Procedures
4-24 Removal and Replacement