AGFA Avantra 36/44 Service Manual page 354

Avantra 36/44 Service Manual
2
3
–Three motor mounting screws. –Drive motor allen screw. –Drive gear.
4. Pull the encoder plug from the motor.
5. Remove the four (4) 1/4" screws, two (2) on each side, securing the motor.
Refer to Figure 2-5.
6. Cut the tie wrap holding the wires to the motor.
7. Remove the three (3) 3/16" motor mounting screws from the back of the
motor bracket. Refer to Figure 2-5.
8. Remove the set screw from the gear. Refer to Figure 2-5.
2-6 Removal and Replacement
1
Figure 2-5 Buffer roller drive motor.
–Buffer carriage. –Buffer roller drive motor.
–Screws securing motor (two each side).
4
5
6