AGFA Avantra 36/44 Service Manual page 176

1
4
6
Figure 4-12 Inner take-up (nip) jam sensor.
–Inner take-up drive (nip) assembly. –Take-up jam sensor.
–1/4" hex head screw in tie clamp. –Two 1/4" hex head screws on bracket.
4. Using a 1/4" nut driver, remove the 1/4" hex head screw holding the tie
clamp. Refer to Figure 4-12.
5. Using a 1/4" nut driver, remove the two (2) 1/4" hex head screws
securing the sensor bracket to the take-up drive (nip) assembly.
Carefully slide the bracket toward the motor to clear the jam sensor
wheel. Refer to Figure 4-12.
6. Using a 1/4" nut driver, remove the nut securing the sensor to the bracket.
Refer to Figure 4-12.
2 5
–1/4" hex nut on sensor.
Section I: Imagesetter
Removal and Replacement 4-17