Crane Removal/Replacement Procedures; Crane On/Off Switch - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
2.2 Crane Removal/Replacement
Procedures

2.2.1 Crane On/Off Switch

Tools Required: phillips head screwdriver
Remove:
1. Power down the OLP and disconnect its power plug.
2. Remove the top covers and, using a phillips head screwdriver, remove the
four (4) screws on the top and three (3) screws on the bottom of the right
side panel. Refer to Figure 2-1 and 2-2. Lift and remove the side panel.
Figure 2-1 OLP cover and panel identification and location.
–Forward top cover. –Middle top cover. –Rear top cover. –Top side panel.
2-2 Removal and Replacement
1 2 3
4