Electronic Enclosure Cover - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual

4.2.3 Electronic Enclosure Cover

Tools Required: 1/4" nut driver
Remove:
NOTE: The electronics enclosure is located inside the right side
cover.
1. Open the right side cover. See Section 4.2.1, Right/Left Side Covers.
2. Remove the three (3) 1/4" hex screws at the bottom of the electronics
enclosure. Refer to Figure 4-6.
3. While holding the electronics enclosure cover with one hand, loosen one
(1) 1/4" hex screw located at the top right side. Refer to Figure 4-6.
NOTE: The screw also secures a cable clamp for the power supply
cable going to the control panel.
Figure 4-6 Electronic enclosure cover (screw locations).
4. Slide the electronics enclosure down and remove it from the system.
Replace:
1. Reverse the above procedure.
4-8 Removal and Replacement
–1/4" hex screw. –Three 1/4" hex screws.
2
1