8. Cut the tie wraps on the motor. Refer to Figure 4-11.
4
1
2
Figure 4-11 Inner take-up drive (nip) motor assembly
–Inner take-up drive motor assembly. –Two 1/4 " hex screws.
–Bracket. –Tie-wrap .
9. Disconnect the power plugs from the motor. Refer to Figure 4-9.
NOTE: For purposes of replacement, the power sockets are
marked: 1 = red wire; 2 = brown wire.
10. Disconnect the encoder plug from the motor. Refer to Figure 4-9.
11. Before removing the motor, test the backlash between the drive motor gear
and the drive roller gear.
This same backlash will be required after installing the new drive motor.
12. Using a 1/4" nut driver, remove the two (2) hex nuts attaching the motor to
the bracket. Refer to Figure 4-11.
13. Remove the allen screw from the motor gear. Refer to Figure 4-11.
14. Remove the motor.
3
6
5
–Motor gear.
–Allen screw.
Removal and Replacement 4-15
Section I: Imagesetter