Take-Up Jam Sensor - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
Replace:
1. Install the take-up drive motor using the two (2) 1/4" bracket screws
removed in Step 11 in the removal procedure above. Refer to Figure 4-11.
2. Install the motor gear. Refer to Figure 4-11.
3. Check the backlash prior to tightening the bracket screws.
4. Turn the take-up drive roller to make sure that it turns smoothly and does
not bind. If it does, the backlash needs to be re-adjusted.
5. Reverse the removal instructions starting with Step 9 to re-install the take-
up drive motor.
6. The take-up drive assembly should be checked for proper operation before
the front panels are replaced.
7. After installing the outer take-up drive assembly and light shield, turn the
system on and launch the AVDIAG program from your PC.
8. Select ALIGN and select Engine Primitives to test the take-up nip solenoids.
9. From the Align menu, enter Display Sensors and check the operation of the

take-up jam sensor.

The take-up jam sensor can be checked by inserting a piece of film down
the right side of the take-up cassette platform until the sensor wheels move
and cause a change in status for the take-up jam sensor.
10. Load the media to check the complete feed function.
4.3.5 Take-up Jam Sensor
Tools Required: 1/4" nut driver, flathead screwdriver
Remove:
1. Remove the inner take-up drive. See Section 4.3.3, Inner Take-up Drive
(Nip) Assembly.
2. Open the right side panel. See Section 4.2.1, Right/Left Side Covers.
3. Cut the tie wraps holding the wires to the motor. Refer to Figure 4-11.
4-16 Removal and Replacement