Intake Fan - AGFA Avantra 36/44 Service Manual

4.4.8 Intake Fan

Tools Required: 3/4" nut driver, screwdriver
Remove:
1. Open the right side cover. See Section 4.2.1, Right/Left Side Covers.
2. Remove the two wires going to the intake fan.
Note the wire color orientation for re-installation.
3. Snap out the plastic removable guide and remove the fan filter.
4. Remove the four (4) hex screws securing the fan to the mount.
1
Replace:
1. Reverse the removal procedure to re-install the intake fan assembly.
2. Turn the system power on and check intake fan for proper operation.
Figure 4-26 Intake fan location.
–Intake fan.
Section I: Imagesetter
Removal and Replacement 4-39