Avantra 36/44 Service Manual
4.8
Bridge Shuttle Motor
Tools: Allen head wrench, flathead screwdriver
Remove:
1. Put the bridge in the up position.
2. Remove the allen head screw from the motor cover on the left. Refer to
Figure 4-6.
3. Put the bridge in the down position to remove the two (2) remaining allen
head screws on the front of the cover. Refer to Figure 4-6.
4. Remove the two (2) power connectors from the bottom of the motor. Note
the wire positions for replacement. Refer to Figure 4-6.
1
3
–Bridge shuttle motor cover. –Three allen screws. –Tie wraps.
4-8 Removal and Replacement
Figure 4-6 Bridge shuttle motor.
–Bridge shttle motor. –Two power connectors.
3
4
5