AGFA Avantra 36/44 Service Manual page 172

10. Follow the sensor cable up to the take-up SDM board on the right side of
the imagesetter. Unplug the sensor cable at its connector (J6) on the board.
Refer to Figure 4-10.
11. Using a 3/16" allen wrench, remove the four (4) bolts, two (2) on each side
of the inner take-up (nip) assembly. Refer to Figure 4-9.
12. Pull the assembly out, rocking it gently.
1
2
–Take-up SDM board. –Sensor cable.
Replace:
1. Reverse the removal instructions to re-install the inner take-up drive nip
assembly.
2. The take-up drive assembly should be checked for proper operation before
the outer covers are installed.
3. After installing the outer take-up drive assembly and the light shield, turn
the system on and launch the AVDIAG program from your PC.
4. Enter the Align menu and select Engine Primitives to test nip solenoids.
Figure 4-10 Take-up SDM board.
Section I: Imagesetter
Removal and Replacement 4-13