Avantra 36/44 Service Manual
Replace:
1. Reverse the removal procedure above.
NOTE: Unlike the wet section temperature sensor, the depth of
insertion in not important.
3.12 Dryer Blower Motor Assembly
3.12.1 Dryer Heater Element
The following describes how to remove and replace the dryer heater element.
Tools Required: Tie cutters, phillips screwdriver
Remove:
1. Turn off and unplug the OLP.
2. Remove the top covers and left side panel.
3. Cut the tie wrap holding the wires to the top right part of the front plate.
Using a phillips screwdriver, remove the screw in the tie wrap holder. Refer
to Figure 3-17.
4. Remove the screw and ground wire in the upper left part of the front plate.
Refer to Figure 3-17.
5. Remove the two screws in the bottom of the front plate. Refer to Figure 3-17.
6. Slide the plate up and out.
3-20 Removal and Replacement