Take-Up Punch Assembly - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
Replace:
1. Install the new jam sensor to the Jam Sensor bracket. Do not tighten the
screw. Refer to Figure 4-12.
2. Install the jam sensor bracket into the inner take-up drive assembly. Refer
to Figure 4-12.
3. Adjust the jam sensor so that it does not interfere with the jam sensor
wheel.
4. Tighten the jam sensor screw. Refer to Figure 4-12.
5. Install the jam sensor plug into the main shell connector. Refer to
Figure 4-10.
6. Install the connector back into the take-up SDM board at (J6). Refer to
Figure 4-10.
7. Reverse the above removal instructions starting with Step 2.
8. After installing the inner take-up drive, the outer take-up drive, and the
light shield turn the system on and launch the AVDIAG program from your
PC.
9. Select ALIGN and then Display Sensors and check the operation of the
take-up jam sensor.
The take-up jam sensor can be checked by inserting a piece of film down
the right side of the take-up cassette platform until the sensor wheels move
and cause a change in status for the take-up jam sensor on your PC.

4.3.6 Take-up Punch Assembly

Tools Required: 3/16" allen, 3/8" and 1/2" nut driver, screwdriver
Remove:
1. Remove the outer take-up drive (nip) assembly. See Section 4.3.2, Outer
Take-up Drive (Nip) Assembly.
NOTE: The inner take-up drive (nip) assembly can remain in place.
2. Make scribe marks to the left, right and front corners of the take-up punch
assembly. Refer to Figure 4-13.
The marks aid in the replacement procedure.
3. Remove the take-up punch chafe pan. Refer to Figure 4-13.
4-18 Removal and Replacement