Polarizer Sensor - AGFA Avantra 36/44 Service Manual

Figure 4-34 Spot size sensor location.
–Spot size sensor. –Aperture wheel motor.
4. Remove the hex screw securing the sensor to the SGM casting. Refer to
Figure 4-34.
5. Remove the sensor cable plug from the shell connector removed in Step 2.
Replace:
1. Reverse the above removal procedure.

4.6.5 Polarizer Sensor

Tools Required: Small flathead screwdriver, cutters
Remove:
1. Remove the carriage assembly from the system. See Section 4.5, Carriage
Drive Removal/Replacement Procedures.
2. Remove the sensor shell connector from the carriage board.
3. Cut the tie wraps from the polarizer sensor connector removed in Step 2.
1
2
Removal and Replacement 4-51
Section I: Imagesetter