Avantra 36/44 Service Manual
3.2
Drive Motor
The following describes how to remove and replace the drive motor.
Tools Required: Phillips screwdriver, 13mm socket and ratchet wrench
Remove:
1. Turn off and unplug the OLP.
2. Remove the side panel at the top left.
3. Using a phillips screwdriver, remove the bracket with the encoder sensor/
sensor connector attached. Refer to Figure 3-1.
9
– Drive wheel set screw. –Drive wheel. –Drive belt. –Idler.
–Three mounting bolts. –Encoder disk. –Encoder sensor/sensor connector.
–Drive motor. –Drive motor power connectors (M1, M2).
3-2 Removal and Replacement
8
Figure 3-1 The drive motor.
1
2
3
4
5
6
7