3.1.7 Bridge Parameters
Use the bridge parameters with the Set/Get Parameters command.
NOTE:
These comand/parameters are not normally used for trou-
bleshooting.
0
1
2
3
4
5
6
7
3.1.8 Bridge/Buffer Commands
Send commands to test specific components directly to the bridge/buffer module
via the terminal by typing in the approriate key sequence. The following lists com-
mand numbers, key sequences, and description of available bridge/buffer com-
mands. A "c" precedes the bridge/buffer commands if the command was sent from
the DEC. A "d" precedes if the command was sent from the debug terminal.
Nominal speed
Max Torque
Steps to Processor
DC Motor Speed
Stepper Import Speed
Stepper Length
Nominal Slow Speed
Stepper Export Speed
Section II: Bridge
Diagnostics 3-7