Attaching The Capture Bar To The Bridge - AGFA Avantra 36/44 Service Manual

Figure 1-5 Lifting the cover from the imagesetter.
1.3

Attaching the Capture Bar to the Bridge

This section tells you how to safely secure the crane's capture bar to the bridge.
Tools required: 1/4" allen wrench
In addition to the tools, you will need the bridge accessories kit, which came
with the imagesetter. Open the accessories box and check its contents.
Steps
1. Place the bridge, top up, on a raised surface near the on-line processor
crane.
NOTE: Do not attach the crane's cable hook onto the capture bar
eyelet until the capture bar is secured to the bridge.
2. Remove the light shields in the top part of the bridge.
3. Remove the two (2) screws, left and right, located in the top portion of the
bridge. Refer to Figure 1-6.
Section II: Bridge
Installation 1-5