Section I: Imagesetter
The solenoid plunger attaches around the drive roller via a bushing arm. To open
(release) the take-up rollers, the solenoids are energized for a pre-determined num-
ber of seconds. The solenoid stroke opens a .02" gap between the rollers to disen-
gage the take-up drive, but not enough to disengage the drive gear mesh.
1
2
3
Figure 2-18 The take-up drive assembly.
–Outer nip drive system. –Inner nip drive system. –Aligned rollers.
2.14.5 Media Cutter Assembly
An automatic media cutter is provided on the output side of the drum. See
Figure 2-19. The cutter cuts all required media types, including the optional 8 and
12 mil thick film/plate material. The media cutter assembly is replaced as a com-
plete unit.
Functional Analysis 2-31