AGFA Avantra 36/44 Service Manual page 128

Carriage Motion
This item moves the carriage in the same manner as it operates during imaging. The
Carriage Motion Menu appears as follows:
Spinner On
Carr. Home Pos. (EEPROM)
Home Carriage
Carr. Slew to Position
Image Start
Image End (EOT)
Carr. Image to Position
Abort Carriage Movement
Video Mode
Resolution (Image Speed)
Gate Start (Pixels)
Gate Length (IN.)
These are the carriage motion menu functions.
Menu Item
Spinner ON/OFF
Carriage Home Position
HOME Carriage
Carriage Slew to Position
Image Start
Image End (EOT)
Carriage Image to Position
Abort Carriage Movement
Video Mode
Resolution (Image Speed)
Gate Start
Gate Length
Feed Motor Cal
The "Feed Motor Cal" test calibrates the speed of the Supply Drive Servo Motor to
the speed of the Take-up Nip Drive Servo Motor. The media and supply cassettes
must be removed prior to performing this test. The two values will be stored in the
DEC. DSP/Plate menu in DSP address location 4 and 5.
This test should be performed after replacing either servo motor or supply/take-up
SDM boards
Imagesetter Primitives
This menu item executes imagesetter primitives usually executed by commands
sent between micro-controllers via the SPI communication link.
Spinner Off
863
0
0
0
0
3600
0
25
Function
Turn the spinner on/off.
Set the carriage home position.
Move the carriage to the home position.
Move the carriage to position at slew speed.
Set the starting position for carriage motion at image speed.
Set the ending position for carriage motion at image speed.
Move the carriage to position at image speed.
Abort the carriage motion.
Set the video mode to positive/negative.
Set the imaging speed of the carriage (resolution).
Set the start of beam on.
Set the fast scan size of the image.
Section I: Imagesetter
Diagnostics 3-41