Avantra 36/44 Service Manual
4. Remove the two (2) hex screws securing the polarizer sensor to the
bracket. Refer to Figure 4-35.
5. Remove the sensor cable plug from the shell connector removed in Step 2.
Replace:
1. Reverse the removal procedure above.
4.6.6 Beam Compressor Motor
Tools Required: Small flathead screwdriver, cutters
Remove:
1. Remove the carriage assembly from the system. See Section 4.5, Carriage
Drive Removal/Replacement Procedures.
2. Remove the motor shell connector from the carriage board.
3. Cut all the tie wraps from the compressor to the connector removed in
Step 2.
4-52 Removal and Replacement
Figure 4-35 Polarizer sensor location.
–Polarizer sensor.
1 1