AGFA Avantra 36/44 Service Manual page 250

Avantra 36/44 Service Manual
1
To check the supply spindle disks:
1. Open the spindle under test and place a 1 mil shim between the disks and
then close the spindle.
You should not be able to remove the 1 mil shim easily. If you can then the
supply rollers need to be adjusted first before adjusting the sensors. Only
the top and middle rollers can be adjusted.
2. If the left side disks need adjustment, remove one screw from the bow tie
plastic piece holding the spindle select rod mechanism.
Loosen the other screw and move the assembly up or down depending on
which spindle disks A/B didn't touch.
5-18 Alignment
Figure 5-4 Supply spindle disks.
–Supply spindle disks.