AGFA Avantra 36/44 Service Manual page 152

Local Modem
Configuration:
The recommended local modem connected to the PC is also a GVC 2400BPS Fax/Modem. If
the remote and local modems are the same, command compatibility, data compression, and
data correction features should operate properly. Other modems can be used but they must
meet the requirements in Table 3-5 and Table 3-6.
After the modem has been configured, store the settings in the active configuration profile
(usually 0) with the following command:
AT&W0
Hardware Connection:
After the modem has been configured, perform the following procedures:
1. Connect the 9-pin end of the modem serial cable to the appropriate serial port of the
PC.
2. Plug the DIN connector into the modem.
NOTE:
Depending on the PC used, a 9- to 25-pin adapter cable may be neces-
sary to connect the modem cable to the PC's serial port.
Table 3-5
COMMAND
E0
V1
&D0 Modem Ignores DTR Ready Signal
N0 Disables Auto-mode detection;
Connection Speed Specified by
&K3 Enables RTS/CTS Flow Control
&Q5 FAX Modem Negotiates Error
Correcting Connection
\N3 Selects Auto-reliable Mode
Table 3-6
REGISTERS
S0=1
Wait Time for Remote Carrier
S7=120
S37=9 Desired DTE Connection Speed
DESCRIPTION
Echo Off
Word Responses
Register S37
Auto Answer Enabled
(2 minutes)
Section I: Imagesetter
Diagnostics 3-65