Media Purchase Sensor; Bridge Loop Sensor - AGFA Avantra 36/44 Service Manual

4.3

Media Purchase Sensor

Tools: Phillips screwdriver, 3/16" allen wrench
Remove:
1. Remove the six (6) screws, three (3) on each side, of the bridge foot face
plate. Refer to Figure 4-1.
2. Remove the media purchase sensor connector. Refer to Figure 4-1.
3. Using a 3/16" allen wrench, remove the holding screw.
Replace:
1. Reverse the procedure above.
4.4

Bridge Loop Sensor

Tools: Phillips screwdriver, 5/16" open end wrench
Remove:
1. Remove the six (6) screws, three (3) on each side, of the bridge foot face
plate. Refer to Figure 4-1.
2. Remove the bridge loop sensor connector. Refer to Figure 4-1.
3. Using a 5/16" open wrench, remove the holding nut.
Replace:
1. Reverse the procedure above.
NOTE: Adjust the upper bridge servo motor (slow and fast speed).
Section II: Bridge
Removal and Replacement 4-3