Mounting The Head - AGFA Avantra 36/44 Service Manual

1.3.2 Mounting the Head

Tools required: Flathead screwdriver
Steps
1. Using a flathead screwdriver, remove the end stop mounted at the tip of
the boom arm. Refer to Figure 1-6.
Figure 1-6 The boom with side rails and end stop.
2. Remove the plastic end cover from the head at the rear (the end farthest
away from the cable exit).
Note the power connector behind this cover.
–Boom rail. –End stop.
Section V: Crane
1
2
Mounting 1-7