AGFA Avantra 36/44 Service Manual page 515

11. Remove the E-clip from the guiding bar and slide the bar out. Figure 1-9.
12. By hand, turn the drive coupler clockwise to unwind the cable. Figure 1-9.
13. Using a 5/32" hex wrench, remove the screw from the cable guiding block.
Figure 1-9.
Figure 2-9 Cable drum with guiding bar and block.
–Cable drum. –Slack safety switch wires.
–Two phillips screws for safety switch. –Slack safety switch .
–Guiding bar.
14. Continue to turn the drive coupler clockwise until the set screw is visible in
the drum. Figure 1-10. Use a 1/16" allen wrench to loosen the set screw.
2
3
1
–Guiding block. –One 5/32 " hex screw.
Section V: Crane
4
5
6
7
Removal and Replacement 2-13