Focus Sensor - AGFA Avantra 36/44 Service Manual

4. Loosen the allen screw securing the lead screw of the motor to the casting.
5. Remove the hex screws securing the weak lens motor to the SGM casting.
Refer to Figure 4-38.
Figure 4-38 Weak lens motor location.
6. Remove the plug from the shell connector removed in Step 3.
Replace:
1. Reverse the removal procedure above.
2. Run the FOCUS.FIL file from the PC imager to check the focus adjustment.

4.6.9 Focus Sensor

Tools Required: Small flathead screwdriver, cutters
Remove:
1. Remove the carriage assembly from the system. See Section 4.5, Carriage
Drive Removal/Replacement Procedures.
2. Remove the sensor shell connector from the carriage board.
3. Cut the tie wraps from the focus sensor connector removed in Step 2.
4
–Weak lens motor.
Removal and Replacement 4-55
Section I: Imagesetter