Weak Lens Motor - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
4. Remove the hex screws securing the aperture wheel motor to the SGM
casting. Refer to Figure 4-37.
Figure 4-37 Aperture wheel motor location.
5. Remove the aperture wheel plug from the shell connector removed in
Step 3.
Replace:
1. Reverse the removal procedure above.

4.6.8 Weak Lens Motor

Tools Required: Small flathead screwdriver, cutters
Remove:
1. Remove the carriage assembly from the system. See Section 4.5, Carriage
Drive Removal/Replacement Procedures.
2. Remove the motor shell connector from the carriage board.
3. Cut all the tie wraps from the weak lens motor to the connector removed
in Step 2.
4-54 Removal and Replacement
1
–Aperture wheel motor.