AGFA Avantra 36/44 Service Manual page 495

Avantra 36/44 Service Manual
4. Insert the adapter into the mount and secure with the two (2) set screws
and locking nuts. Refer to Figure 1-3.
Figure 1-3 Inserting the adapter into the mount.
NOTE:
Later OLP models should not require the following proce-
dure.
5. Replace the top side panel to the OLP and verify that the panel cut-out for
the crane has an acceptable fit. Refer to Figure 1-2 and Figure 1-3.
If the fit is not good, remove the adapter and mounting plate. Re-install the
plate with washers added between the mounting plate and the frame. This
will improve the alignment.
1-4 Mounting
2
–Boom. –Adapter (fit into mount). –Mount.
1
3