Buffer Roller Driver Motor - AGFA Avantra 36/44 Service Manual

4
5
Figure 2-4 Buffer carriage drive motor.
–Motor mounting screws. –Lead screw. –Buffer carriage drive motor.
–Electrical connector. –Electrical wiring P-clips.
Replace:
1. Reverse the procedures above.
2.5

Buffer Roller Driver Motor

The following describes how to remove and replace the buffer roller driver
motor.
Tools Required: 1/4" open end wrench
Remove:
1. Remove the top cover from the buffer.
2. Remove the top side panels.
3. Pull the two power plugs from the driver motor.
NOTE:
Make note of the positioning of the two power plugs (red
and brown) for purposes of replacement.
Section III: Buffer
1 2
Removal and Replacement 2-5
3