Avantra 36/44 Service Manual
1
3
4
2
Figure 1-4 Removing the diaper and end plates.
–One of two tie wraps. –End bolts (3 at each corner). –Diaper (removed).
–End plate, 1 at each end (removed).
11. Loosen the two (2) outer channel bolts on either end. Refer to Figure 1-5.
Allow only a small gap of 1/8" between the bolt heads and the beams.
WARNING:
Do not remove the outer channel bolts. Doing so may
result in the imagesetter falling off the jack screw (see succeeding
steps).
The two (2) end bolts hold the channel beams (wood) to the end channels
(metal). The middle bolt holds the center channel; do not remove this bolt
until Step 13.
1-8 Installation