AGFA Avantra 36/44 Service Manual page 43

10. Insert the chafe tray provided (see Figure 1-9) by hooking the ends into the
slots at the bottom and to each side of the exposed area. Refer to Figure 1-
16.
1
Figure 1-16 Inserting the chafe tray.
11. Replace the take-up light shield.
Unlocking the Vacuum Pump
1. Open the right-side door
2. Loosen the four hex screws on the orange tie-down bracket that secures
the vacuum pump.
3. Remove the orange tie-down bracket.
2
–Chafe tray. –Chafe tray hook.
Section I: Imagesetter
Installation 1-19