AGFA Avantra 36/44 Service Manual page 292

Avantra 36/44 Service Manual
1
Figure 1-9 Attaching the foot to the bridge using the foot thumb screws.
–Bridge. –Bridge foot. –Foot thumb screw (one of two).
3. Using a flashlight, look to the left and right of the bridge to make sure that
the guide blocks are not hitting the take-up platform opening. Refer to
Figure 1-10.
If a guide block is hitting, move the bridge left or right to compensate.
4. Check to make certain that the bridge foot lies flat on the take-up platform.
With the bridge up, hold a plastic shim on the take-up platform at the left
rear. Lower the bridge onto the shim and try to pull the shim from beneath
the foot. There should be some resistance. If the shim comes out easily,
the foot is not flat against the platform.
1-10 Installation
2 3