Imagesetter Component
4.1
Introduction
This chapter describes the procedures for removing and replacing components in
the Avantra 36/44 imagesetter.
Topics covered are:
•
Covers
•
Right/Left Side Covers
•
Top, Middle and Bottom Front Panels
•
Electronic Enclosure Cover
•
Media Transport Removal/Replacement Procedures
•
Take-up Light Shield
•
Outer Take-up Drive (Nip) Assembly
•
Inner Take-up Drive (Nip) Assembly
•
Inner Take-up Drive (Nip) Motor
•
Take-up Jam Sensor
•
Take-up Punch Assembly
•
Cutter Assembly
•
Cutter Motor
•
Take-up Media Present Detector
•
Electrical Removal/Replacement Procedures
•
Digital Engine Controller (DEC) PCB
•
Carriage Sensor Driver (CSDM) PCB
•
Operator Control Panel Assembly
•
The Supply and Take-Up Sensor Driver Modules PCB (SDMs)
•
Power Supply
•
Main Power Switch
•
Exhaust Fan
Removal/Replacement
Chapter 4:
Procedures
4-1