AGFA Avantra 36/44 Service Manual page 112

CLOSE LOG FILE
This closes the opened log file above.
Download File
• Command Files
This program allows the creation of ASCII command files containing a
sequence of commands to be sent to the imagesetter's remote diagnostic
port. This is a description of the command files supplied with the program
and the text of typical command files.
CAUTION:
Running some of the command files below could cause
system problems. Refer to table footnotes for details.
The current set of command files include:
Command
*
SETMPS52.CMD
SHIP.CMD
CARRSLEW.CMD
SUPLFEED.CMD
REVFEED.CMD
IMGFEED.CMD
*
MEDIA.CMD
*
SETIPS.CMD
*
SETMPS.CMD
* You should back up your machine parameters prior to running these commands. These commands
load old default values or zero out some machine parameters. This causes system problems, if the
backed up machine parameters are not downloaded to the imagesetter after running these tests. Some
of these command files have been eliminated from newer releases of AVDIAG software.
Function
Sets Media Parameters prior to FSB #10
Used by Manufacturing prior to system being shipped
Repeatedly slew the carriage in both direction
Execute the feed motors as if loading media
Execute the feed motors as if unloading media
Execute the feed motors as if feeding media normally
Sets Media Parameters prior to FSB #10
Write the default imaging parameters to the imagesetter
Write the default machine values to DEC. EEPROM
Section I: Imagesetter
Diagnostics 3-25