3.12.2 Dryer Blower
The following describes how to remove and replace the dryer blower.
Tools Required: Tie cutters, phillips screwdriver
Remove:
1. Turn off and unplug the OLP.
2. Remove the top covers and left side panel.
3. Open up the upper half of the dryer section.
4. Remove the heating elements. See the removal procedure in Section 3.12,
Dryer Blower Motor Assembly above.
5. Remove the two (2) screws at the top of the dryer/blower unit. Refer to
Figure 3-19.
6. Cut the tie wraps around the sensor on the frame. Cut the tie wrap holding
the wires to the left side of the dryer/blower housing. Refer to Figure 3-19
and Figure 3-20.
7. Using a phillips screwdriver, remove the two (2) screws securing the sen-
sor to the frame. Refer to Figure 3-19.
Section IV: On-line Processor
Removal and Replacement 3-23