AGFA Avantra 36/44 Service Manual page 341

Avantra 36/44 Service Manual
13. Leaving the platen alignment pins in place, tighten the four (4) nuts (each
end) on the brackets attached to the extension platen. Refer to Figure 1-11.
CAUTION:
platen, check that the set of alignment holes in the bridge still line
up with the set in the extension platen. If the holes do not align,
loosen the nuts and repeat Steps 11 and 12.
14. Place the labels provided over the top of the extension platen alignment
holes.
The labels prevent light leakage.
15. Move the buffer against the imagesetter.
The imagesetter extension platen should fall within the buffer platen.
16. Screw the buffer leveling feet about one full turn so that the buffer is flat
against the imagesetter. Align the mounting holes by adjusting the leveling
feet. Refer to Figure 1-13.
NOTE:
Lowering the feet takes pressure off the securing screws,
which are used to attach the buffer and imagesetter in the
next step.
1-14 Installation
With the bracket tightly secured against the extension