AGFA Avantra 36/44 Service Manual page 288

Avantra 36/44 Service Manual
Figure 1-6 Attaching the capture bar and brackets to the bridge.
–Bridge. –Capture bar. –Two capture bar brackets.
4. Using the bridge screws, attach the left bracket to the bridge. Refer to
Figure 1-6.
The left bracket is for the roll pin side of the capture bar.
5. Using one of the two (2) 9/16" bolts and washers provided, secure the
bracket to the side of the bridge. Refer to Figure 1-6.
6. Insert the roll pin side of the bar into the bracket.
7. Insert the cap side of the bar into the right bracket.
8. Using the bridge screws, attach the right bracket to the bridge. Refer to
Figure 1-6.
9. Using the remaining 9/16" bolt and washer provided, secure the right
bracket to the side of the bridge. Refer to Figure 1-6.
10. Screw the gear collar clamp onto the capture bar to hold it in place against
the bracket.
1-6 Installation
2
3
1