AGFA Avantra 36/44 Service Manual page 196

2. Loosen the 1/4" hex screw securing the plate over the power-on switch.
Refer to Figure 4-24.
Figure 4-24 Main power switch and plug locations.
3. Slide the plate down and out of the OCP.
4. Remove the brown and blue wires going to the power switch. Refer to
Figure 4-24.
Note the wiring orientation for re-installation.
5. Using your fingers, squeeze both the top and bottom back of the switch
while pushing the switch forward through the control panel bezel.
Replace:
1. Reverse the removal procedure to re-install the main power switch.
2. Turn the power on and check the power light-on switch.
1
–Main power switch and plugs.
Section I: Imagesetter
Removal and Replacement 4-37