1.1
Introduction
This chapter describes the steps necessary for installing the internal bridge and
for insuring that it functions properly.
The following takes you through the necessary procedures:
•
Removing the Imagesetter Top Cover
•
Attaching the Capture Bar to the Bridge
•
Raising and Lowering the Bridge into the Imagesetter
•
Attaching the Bridge to the Imagesetter
•
Attaching the Bridge Foot
•
Attaching the Gas Shocks
•
Adjusting the Detent Plate
•
Aligning the Solid Stops
•
Setting up the DEC to Bridge/Buffer Interface
•
Attaching the Ground Wires
Bridge Installation
Chapter 1:
1-1