Luth Motor Control Board - AGFA Avantra 36/44 Service Manual

3.4

LUTH Motor Control Board

The following describes how to remove and replace the motor control board.
Tools Required: Phillips screwdriver, needle-nose pliars
Remove:
1. See the removal procedures in Section 3.3, CPU-OLP for exposing the
board.
2. Remove the connectors at X5 and X7. Refer to Figure 3-7.
3. Remove the connectors at X6 and X2. Refer to Figure 3-7.
NOTE: Note the position of the power connectors for replacement.
4. Using a needle-nose pliars, release the two (2) nylon standoffs from the
front of the board. Refer to Figure 3-7.
5. Using a phillips screwdriver, remove the mounting screws at the rear.
Refer to Figure 3-7.
1
10
9
Figure 3-7 The LUTH motor control board.
–Motor control board. –Two rear mounting screws. –X5 connector.
–X7 connector. –Two mounting standoffs. –Motor board and CPU LED
alignment. –CPU board. –Jumper fuses. –X6 wiring.
Section IV: On-line Processor
2
3
4
8
Removal and Replacement 3-9
5
6
7
–X2 wiring.