5. On the left side of the system, disconnect the spin motor cable, spin motor
encoder cable, carriage motor cable and analog encoder cable from the
CSDM PCB. Refer to Figure 4-20.
1
6
5
4
Figure 4-20 Carriage sensor driver module PCB (CSDM) (left side).
–CSDM PCB. –3/16" hex screws and retaining clip.
–Spin motor cable connector. –Spin motor encoder cable connector.
–Carriage motor cable connector.
6. Remove the two (2) 3/16" hex screws and retaining clip securing the CSDM
to the carriage assembly. Refer to Figure 4-20.
7. Slide the PCB out of the carriage assembly.
Section I: Imagesetter
3
–Analog encoder cable connector.
Removal and Replacement 4-29
2